星空天美麻花视频大全

超声波清洗机温度设定:按加热翱狈键,再按加热翱贵贵键,根据您所需要的操作温度按下设定键“上”或“下”,设定键允许所希望的操作温度在10℃-80℃之间。每按一次表示设定加热温度增或减1℃,一般工件清洗要求水温在60℃左右。

Temperature setting of ultrasonic cleaning machine: press the heating on key, and then press the heating off key. Press the setting key "up" or "down" according to the required operating temperature. The setting key allows the desired operating temperature to be between 10 ℃ and 80 ℃. Each press indicates that the set heating temperature increases or decreases by 1 ℃. Generally, the water temperature for workpiece cleaning is about 60 ℃.

一旦温度选中后,按温度加温翱狈键,加温鲜红色显示灯会亮,表达刚开始加温,显示屏刚开始显示信息精确测量当今器皿内的具体温度。当温度超过所设置的温度时加温鲜红色显示灯会灭掉,温度电加热器会终止加温。

Once the temperature is selected, press the temperature heating on key, the heating bright red display light will be on, indicating that the heating has just started, and the display screen has just started to display the information to accurately measure the specific temperature in today's utensils. When the temperature exceeds the set temperature, the heating bright red display light will be off, and the temperature electric heater will stop heating.

当温度降到低于您设定的温度时,温度、水位、时间、功率显示器上显示 059 010 020 100,温度加热器会自动加热,加热红色指示灯会亮。当清洗槽内水温超过10℃时,温度、水位、时间、功率显示器上显示 011 010 020 100 ,表示可设定超声波动作时间和超声波功率，温度超过规定温度的80℃时温度显示器闪烁，温度低于80℃时停止闪烁，表示可进行超声波清洗。

When the temperature is lower than the temperature you set, the temperature, water level, time and power display will display 059 010 020 100, the temperature heater will heat automatically, and the heating red indicator will be on. When the water temperature in the cleaning tank exceeds 10 ℃, 011 010 020 100 is displayed on the temperature, water level, time and power display, indicating that the ultrasonic action time and ultrasonic power can be set. When the temperature exceeds 80 ℃ of the specified temperature, the temperature display flashes, and when the temperature is lower than 80 ℃, it stops flashing, indicating that ultrasonic cleaning can be carried out.

设定温度是在不打开超声波的情况下设定的。 不打开时，温度设定键无效。 请注意，微处理器是记住的

The set temperature is set without turning on the ultrasonic. When it is not turned on, the temperature setting key is invalid. Note that microprocessors are remembered

超声波清洗机一般在30℃-40℃下清洗效果较好，清洗液温度越高，效果越明显。通常，超声波清洗机实际使用时，工作温度为50-70℃。

Ultrasonic cleaning machine generally has better cleaning effect at 30 ℃ - 40 ℃. The higher the temperature of cleaning solution is, the more obvious the effect is. Generally, the working temperature of ultrasonic cleaning machine is 50-70 ℃.